Brake Control Wiring Install: CURT 51515 for 2008-2012 Chevrolet Silverado

Welcome to the installation video of the curt five one five one five quick plug brake control wiring harness with pigtails on the 2012 Chevrolet Silverado 1500 we estimate this installation to take between 15 and 30 minutes depending on your level of expertise we suggest that you disconnect the negative terminal of the battery for safety first let's go over the tools necessary for the install you will need a crimp tool butt connectors a 10 millimeter wrench and electrical tape start by locating the vehicles electric brake control harness bundle the harness should be located underneath until the left of the steering column tape to another harness near the emergency brake pedal remove the taper on the vehicle's harness and separate the wires the colors to functions are as follows the dark blue wire is the brake output to trailer the red wire with black stripe is 12 volt positive the light blue wire with white stripe is the stop signal and the white wire is ground use the crimper tool to strip each of the four wires prepare the wiring harness by removing the white tag to reveal the bare wires attached and crimp the butt connectors to each of the four exposed wires be sure to crimp the exposed portions of the wires now that the butt connectors have been cramped you are ready to connect the harness to the vehicle's wiring connect the blue brake output wire to the blue wire on the harness then connect the white ground wire to the white wire on the harness next connect the red stripe 12-volt positive wire to the black wire on the harness finally connect the light blue stripe stop signal wire to the red wire on the harness on this specific vehicle we suggest mounting your brake control here for easy and quick access once your brake control is in place route the harness wiring.

That it will not be in the way of normal vehicle operation connect the quick plug of the harness to the quick plug on the brake control and tuck away any excess wiring if your vehicle is new and has never had a brake control installed before there's a good chance that you will need to connect the circuit to activate power to the unit from underneath the hood remove the engine compartment fuse box cover the aftermarket power feed wire is located between the fuse box and the driver side quarter panel using the ten millimeter wrench remove the nut from the auxiliary power terminal at the front of the fuse box place the eyelet of the power feed wire over the terminal and secure the nut replace the fuse box cover and reconnect the negative terminal of your battery this completes the installation of the curt five one five one five quick plug brake control wiring harness with pigtails on the 2012 Chevrolet Silverado 1500 still need information on how to use your curt brake control find all that and more at curtam of g.com curt the first name and towing products.

Brake Control Wiring Install: CURT 51515 for 2008-2012 Chevrolet Silverado

YT Stats Views: 0 Likes: 0 Dislikes: 0