Chicco Tre Stroller - Removing and Installing Soft Goods

To use tray as a frame carrier you can remove the seat first set the park brake remove the bumper bar and canopy from the stroller unzip the seatback fabric at the top of the stroller then unbutton the two fabric tabs located on the back of the stroller behind the arm rests on each of the handle tubes locate the fabric attachment plates push in both snap locks and slide the attachment plate from the frame repeat for the other side pull the attachment plates towards the front of the stroller release the hook and loop tabs under the footrest fold over the footrest fabric locate the buckles under the sides of the seat pad and buckle the clip in order to contain the seat fabric locate the two levers on the back of the seat pan then pull up on both levers hold back on the seat pan to remove it from the stroller frame with a seat removed the arm bar can be reattached to accept the key fit infant seat the canopy can be reattached if desired to install the seat first set the part break remove the bumper bar and canopy from the stroller line up the seed frame with the side rails on the stroller and slide it forward until it clicks into place being sure that the dovetail features line up correctly and properly engage at both the front and back of the seat unbuckle the clip to release the seat fabric and tuck the clips under the seat fabric secure the hook and loop tabs under the footrest fabric insert the attachment plates into the clips on the sides of the handle tubes being sure that the plates are securely installed then zip the seat back fabric to the cross bar at the top of the stroller attach the two fabric tabs on the back of the arm bar reattach the canopy and bumper bar.

Chicco Tre Stroller - Removing and Installing Soft Goods

YT Stats Views: 7 439 Likes: 0 Dislikes: 0